Tailgate LED Strip Light has a streamer design that can be used as a Tail light, Running and Driving Light, Turn Signal Light, Brake light, Parking light, Hazard flashers, Reverse light and more modes.
LED lights are one of today’s hottest styling upgrades, showing up on grilles, bumpers, side mirrors, running boards, and many more parts of the vehicle. And now you can add Tailgate Lights to the back of your car. when you running your car, it will creates a dazzling, bright display that will be appreciated by car and truck buffs. It lets you more younger and personalized~
At night and during inclement weather. Tailgate Lights are appropriate for brake lights to caution other motorists, to the benefit of your safety. Tailgate Lights can effectively prevent and reduce the occurrence of car rear-end accidents.
Silicone Housing is good for waterproof, never afraid of any weather like torrential rain, snow storm…
The light bar comes with 3M double-sided adhesive straps which has a strong sticker. Once attached with 3M tape, your light bar will stay where it’s installed.
Tailgate Lights own 48~60pcs super bright LED lamps, environmentally friendly, no pollution, no radiation, long service life.
The wire ends of our Tailgate Lights are designed with pins, supplying for non-destructive installation without breaking the original power. Just stick the tail light at the edge of trunk, and connect the wire according to the instructions.
Specifications:
Voltage DC: 12 V
LED type: SMD5050RGB
Housing color: clear
Light color: multi color
Light strip size:
48LED(1200X15X5MM)
60LED(1500X15X5MM)
Wire size: 7X25CM
Materials: LED Chip set + Silicone Housing
Waterproof: IP65
Multi Color Tailgate Light Working:
Brake light: red light.
Driving mode: keep multi color light.
Reversing light: white light.
Left turn: Yellow light streamer mode right to left.
Right turn: Yellow light streamer mode left to right.
Double flash: The Yellow light streamer mode from the middle in both sides at the same time and the same speed.
Auto tail lamp box wiring instructions:
Controller input circuit description: cable, a total of six ( black, red, white, green, yellow, blue )
1. The black wire connects to the car battery cathode.
2. The red wire connects to the car battery anode ( ACC ), driving iridescence.
The green wire connects to the ACC ( or width modulation ), driving iceblue.
( Only one of the two wires can be selected for connection )
3. The white line connects to the brake light.
4. The yellow line connects to the right turn signal.
5. The blue line connects to the left turn signal.
Installation method:
Step1: Please confirm the installation site, clean up the interface.
Step2: Connect the connector.
Step3: Wiring and install to the collect position.
Step4: Press it to make them fit closely.
Reviews
There are no reviews yet